2007 Peterbilt 367 Cozad 7 Axle Transport

*READ v BELOW v*

*<--MUST READ BEFORE USE-->* 

**CONTROLS:**

*L:* For Headlights 

*N:* For Lights

*J:* For Beacon

There is Buttons for you to click and how to use, read below.

***NOTE:***

Their is alot of clicking involved. So if you have used my other 9 axle and my 60 ton before then this should be fairly easier to you. On the very REAR CORNERS of the trailer theirs buttons to open a ramp to Load the equipment from the rear. THEIR IS also button on the GOOSENECK to detach from the tractor or to detach gooseneck from the trailer. Where the ramp is on the gooseneck, there is also buttons to open a ramp to load it. At the Driver Side Rear Side their is a GUI to open a winch to LOAD FROM REAR. On the bed, at the end their is also a clicker to open a GUI to winch in and load it from where the gooseneck becomes disconnected. Their is also more ramps but that's to load it a certain way. You can ignore it. 

(RECOMMENDED:) Winch in the Equipment and click weld. Once loaded and it doesn't drive once welded, Go into neutral and REV it, then go into gear, to give it enough torque.