[050] Centrifugal Pump MS Template [MS Word]

CENTRIFUGAL PUMP Method Statement [including the Checklist] Template and Instructions, based upon our article, in [Microsoft Word] format allowing editing for your full use.

---

Please note that as each project and system is different there will need to be tweaks and slight modifications needed. 

Pages: 42
Words: 4,215

Table of Contents

1      Introduction
2      Engineers Qualifications and Experience
3      Documentation & Reference
4      Specific Design Information
4.1   Equipment Design Flow Rates / Head Pressure
4.2   BMS Points, Alarms and Control Logics
5      Project & Equipment Information
6      Pump Technical Details
7      Acceptance Criteria & Tolerances
8      Permit to Work
9      Inspection, Sign Off and Defect Management
10    Delivery Inspection
11    Storage Inspection
11.1     Storage Area
11.2     Storage of the Equipment
12     Pre-Installation Inspection
13     Maintenance/Access
14     Pre-Commissioning Inspection
14.1     General
14.2     Room and Area Finishes Inspection
14.3     Electrical General
14.4     Variable Speed Drive
14.5     Pumps/Pipework
14.6     Controls
15     Equipment/Instruments
16     Pump Alignment
17     Pump Functional Testing
17.1     Insulation Resistance Test of Motor [1]
17.2     Rotation Check [2]
17.3     Emergency Stop Test [3]
17.4     Closed/Dead Head Test [4]
17.5     Plot Pump Curve [5]
17.6     Pump Motor Start & Running Currents [6]
17.7     Pump Full Flow Test [7]
18     Comments/Observations
19     Signatures and Witnessing

Appendix A – Material Submission
Appendix B – Water Side Mechanical Schematic
Appendix C – Water Side Mechanical Layout
Appendix D – Pump Curves
Appendix E – Equipment Data Sheets
Appendix F – Calibration Certificates