Load-it-Up Laptop Slipcase

The Load-it-Up Laptop Slipcase is a custom fit, DIY fabric laptop case that’s slightly different from most. It actually has room to tote along your power cord/charger, mouse and other accessories that you might want to keep with your computer. Lightly padded, it will hold everything you need to run your laptop or tablet. Included in this version are sizing charts (in both imperial and metric) to determine the precise amount of fabric needed for your specific laptop.

This is a 23-page PDF, with over 45 photos to guide you to success.

Supplies required:

• Non-directional exterior fabric for Main Body Exterior (amount/size as determined by your needs)
• Fabric for Main Body Lining (preferably non-directional; amount/size as determined by your needs)
• Matching/coordinating fabric for Bellows Pocket Exterior and Lining (both 8.5" long x 10" wide, or 21.6cm long x 25.5cm wide) — note that this pocket is sized so as to fit a case made for even the smallest laptop; you may wish to increase the width by an inch or so if your laptop is 15" or bigger
• Medium weight fusible interfacing for Main Body Lining (cut 1/2" shorter and 1" narrower than Main Body Lining fabric piece)
• Medium weight fusible interfacing for Bellows Pocket Exterior (8" long x 9.5" wide, or about 20.5cm long x 24cm wide) — adjust appropriately if you widened the pocket pieces
• Twist lock set
• Regular (low loft) fusible fleece for Main Body Exterior (cut 1/2" shorter and 1" narrower than Main Body Exterior fabric piece)