Dynamic EQ with EzSVG v1.0.2

Q-SYS plugin Dynamic EQ with EzSVG

This plugin depicts the equalizer curve in EzSVG, which cannot be pasted into UCI.

Please note that the Gain calculation is not completely accurate.

In addition, it has a dynamic EQ behavior not found in normal EQs.

Only bands 1 and 8 have High and Low Pass filters.

You might think that depicting EQ is straightforward, but in reality, this depiction is generated entirely from calculations done from scratch. The calculations are so complex that I can hardly remember how I came to this result myself. The sampling range extends from 10 Hz to 20 kHz, with 1000 points sampled. I believe the representation is quite accurate, but it’s not perfect. However, the internal EQ is original and works flawlessly. I would appreciate some acknowledgment for the effort that went into these calculations.

--v1.0.2----------------------------------20241228

Performance improvements (fixes to Threshold Over / Under event handlers)

Reduced maximum Ramp Time from 2s to 1s

--v1.0.1----------------------------------20241224

Add a feature that allows switching between Over and Under

when the volume exceeds the threshold set with Dynamic EQ enabled.

--v1.0.0----------------------------------20241205

Initial release

--------------------------------------------

Usage:

Please refer to the following

https://emastered.com/blog/what-is-dynamic-eq

*Note and Caution-----------------------------------------------------

As you know, use this plugin at your own risk.

*Test Equipment

QDS ver 9.10.2

UCI Viewer v9.10.2

iPad UCI Viewer v3.10

*Known isses-------------------------------------------------------------

v1.0.2

When Bandwidth is too small, the EQ may not be accurately portrayed if Gain is too large.

The same is true when Shelf is entered.

However, even if the EQ is a little inaccurate, it is still accurate because the internal EQ is the genuine QDS PEQ.

Even when the range value is changed with dynamics enabled, the value remains as it was when dynamics was enabled and the change isn’t immediately reflected. I'm currently looking into a fix.