Patent Leather hand painting kit

Patent Leather Hand painting Repair Kit.

Repair ebook & video pdfs available please send a message

Includes: 

2 oz Patent leather paint

2 oz Wipe on Sealer

1 oz Leather Filler

2 streak free wipe on sealer sponges

2x sanding pad level 1 & level 2

1 sanding sponge 

1 paint roller ( size may vary from 1" to 2 " )

1x 400 grit sandpaper

1x 320 grit sand paper

1x 80 grit sandpaper 

1x 120 grit sandpaper

Instructions:

Moderate damage ( Scuffs , Fog , haze , smearing , spotting or blur )

1. Begin by removing the top coat of the patent leather with acetone & a cotton ball

2. Sand he surface of the patent leather with 120 grit sanding paper

3. Apply patent leather filler to all damaged areas. Allow filler to dry for 30min to 1 hr

4. Use 80 grit sandpaper to sand dry filler .... if excess filler is hard to remove add soap & water to enhance surface power and create a smooth suface.

5. Apply patent leather paint generously to damaged areas. About 3-4 coats should cover damages depending on severity. Allow paint to dry for 3 - 4 hours before sanding

Note you can lightly sand in between coats after an 1 hrs time.

6. Lightly wet the grey sanding block with dish soap & water to smooth out any paint imperfections . If brush strokes or rolling pores are heavy wet the blue pad level 1 with soap & water to blend until surface is smooth

7. Wipe surface & allow to air dry for 30 min to 1hr then dry sand with 400 grit sandpaper then 320 grit sandpaper

8. Apply 10 - 12 ml or about a tablespoon of patent leather wipe on sealer to right angle non streak application sponge. Then apply the final sealer around the sneaker. Allow to dry for 24 hours before touching.

Note : One or more coats may be nessecary in some cases.

Also if drip is present after drying or the finished surface is unsatisfactory. Reset & reapply sealer

1. Use level 1 blue pad to sand

2. Use angled sanding sponge to sand

3. Use streak free sponge to sand

4. Reapply sealer