X-Shot Micro Reshell 4 v1.0 - Hammer-Action - FILES ONLY

This is a 3D-printable shell from the GenCo Microwerks for the X-Shot Micro, a tiny powerhouse of a blaster. All the hardware you need is already provided by the Micro itself. You just need to print parts in the colors of your chosing and you’re good to go to take a screwdriver to it.

The fourth reshell uses one Micro, but drives it with a thumb-primed hammer. That makes this blaster usable with one hand. (Well, except for the loading part. This is still single-shot.) Getting that hammer shaped into the right leverage for that beef of a prime took a few attempts.

---

All parts can be printed on a bed of 180mm edge length. You can print most pieces without supports. All of them if your printer is good at bridging.

The assembly instructions can be found here -> https://wildwestscifi.net/x-shot-micro-reshell-4-hammer-action-assembly-instructions

---

https://www.youtube.com/watch?v=50SXxawdjyw <- Maritimefoam has an overview and assembly video of this blaster.

---

Changelog: 

v1.0

- Initial Release.