John Deere Series 300 3029 (—499999),4039 4045, 6059 and 6068 Diesel Engines CTM8
John Deere Series 300 3029 (—499999),4039 4045, 6059 and 6068 Diesel Engines CTM8
The changes listed below make your CTM obsolete.
Discard CTM 8 dated 23FEB95 and replace with this
new manual. Also, copy these pages and route
through your Service Department.
GROUP 01
· Updated engine model designation chart.
· Updated serial number plate information.
GROUP 02
· Updated engine application chart.
· Updated engine oil and coolant application
guidelines.
GROUP 04
· Updated sealant application guidelines.
GROUP 05
· Revised valve clearance adjustment procedure.
GROUP 10
· Revised procedure for removal and installation of
cylinder liners.
· Added specifications for 32 mm piston pin.
GROUP 15
· Revised procedure and specifications for removal
and installation of vibration damper to include
available options.
· Revised specifications for flywheel installation.
· Revised procedure for removal and installation of
rear oil seal and wear sleeve.
· Revised crankshaft grinding guidelines.
GROUP16
· Revised timing gear backlash specifications.
· Revised procedure for removal and installation of
camshaft and gear.
· Revised procedure for removal and installation of
front plate.
· Revised procedure for removal and installation of
idler gear shafts and bushings.
· Revised procedure for transfer of front plate timing
mark.
· Revised timing gear cover installation specifications.
GROUP 20
· Added remote oil filter repair procedures.
· Revised procedure for replacement of oil pickup
tube.
· Revised oil pan retaining cap screw specifications.
GROUP 25
· Revised water pump pulley-to-pump housing
specifications.
GROUP 30
· Added recommendations for turbocharger use.
GROUP 35
· Revised specifications for injection pump drive gear
retaining nuts.
· Revised procedure for inspecting valve adjusting
mechanism.
· Revised procedure for assembly of fuel injection
nozzles.
GROUP 40
· Added new Group 40 covering removal and
installation of starting motors and alternators.
GROUP 100
· Revised altitude performance specifications
· Revised dynomometer test specifications.
· Revised engine break-in procedure.
· Added engine oil consumption information.
GROUP 105
· Added engine cranking speed test.
GROUP 110
· Added turbocharger oil seal leak test.
· Added intake and exhaust restriction check.
· Revised turbocharger boost specifications.
GROUP 115
· Revised fuel injection pump specifications.
· Added procedure for using TIMETRAC as a
tachometer.
· Added fuel shut-off solenoid test (Lucas pumps).
· Revised theory of operation on primary fuel filter.
· Added theory of operation on final fuel filter.
· Added fuel supply quality check.
· Added air in fuel test.
· Added restricted fuel return line check.
Pages:682
File Format: Pdf
Compatible: All Versions of Windows & Mac
Language: English
Delivery: Instant Download