HRKF - Headlight Relay Kit, Full

HRKF - Headlight Relay Kit, Full

  The Full Relay Kit has everything you need to add relays to your headlight circuit - without cutting your original wiring.

The -2 model is for earlier cars that have 2 wire headlight harness connectors instead of the 3 wire connectors used on later vehicles.

Included in kit: 2 weatherproof controllers, a 35A auto-reset circuit breaker, power wire, crimp-on connectors and easy to follow instructions.

Benefits:

• Easy to install, and no cutting. Plug in the controllers, run a power feed and you're done.
• Redundancy. Each headlight - High, Low, Left, Right has it's own relay and each side has it's own controller.
• Each 40/60 Amp 12 Volt sealed relay has Negative Spike Protection built in. This means no spikes or feedback to upset delicate electronics.
• Each controller contains an internal auto resetting circuit breaker to isolate left and right sides.
• If a controller goes bad, remove it. The OEM circuit will power those bulbs.
• The single feed wire is easily hidden and the controllers can be removed for car shows if desired.
• Compact size - each controller is only 3x2x1.5.
• Kit comes with 35A circuit breaker to power up to 4 halogen lamps at 7.5A each and is auto resetting.
• Notes:
• ¹ It is the responsibility of the purchaser to ensure that the vehicle's wiring is in suitable condition to supply power to the installed lamps.
• ² If your vehicle does not have extension connectors you need the HRKU kit below.
• ³ This kit is for cars with separate headlight harnesses. 71-73 Mustangs use the HRKU-2 kit below.