stitch candleholder file

🕯️ Candle Holder

Designed to fit standard Bath & Body Works 3-wick candles and add a little extra personality to your candle setup.

As with my other candle holder designs, I highly recommend using the candle lid as a base between the candle and the print to help keep the candle away from the printed surface.

Happy printing! 🖤🕯️

For faster printing, print the holder at a slight tilt/angle to help reduce overall print time. You can also bump up your print speed to cut the time down further.

Never leave a burning candle unattended.

🖨️ PRINTING TIP — SHORTEN YOUR PRINT TIME

To help cut down the long print time on the coozie, start the print at Normal speed for the first 30 minutes. This gives the base layers plenty of time to get good adhesion and establish a solid foundation.

After the first 30 minutes, you can increase your Bambu printer speed to:

🏎️ Sport Mode — Faster with a good balance of speed and quality

🚀 Ludicrous Mode — Fastest option if your printer/filament is handling the print well

I personally recommend keeping an eye on the print for a few minutes after increasing the speed to make sure everything is printing smoothly.

Always start on Normal then let her rip! 😂

Print times shown in the slicer are based on Normal speed, so your actual completion time may be considerably shorter when using Sport or Ludicrous mode.