User Units and Pure Data Patches for NTS-1 mkII

20 user units for KORG NTS-1 mkII. All units are built with the Pure Data to NTS-1 mkII converter. Ready-to-go binaries and Pure Data patches are included.

Oscillator

- Sync.pd Synced sine wave oscillator.

- Detune.pd Two sine oscillators with slightly different frequencies.

- Draw.pd Hand-drawn waveform oscillator.

- PitchShift.pd Shifts the pitch of the AUX IN signal.

- 7ch-Vocoder.pd 7-band vocoder. Connect the modulator (voice) signal to AUX IN.

* To enable AUX IN for oscillator units, hold the REVERB button and turn NTS-1 mkII on, then set the Inr. value to 0. Press ARP to save and restart.

Modulation FX

- SampHold.pd Resamples the input at 400 Hz–16 kHz.

- BitCrush.pd Reduces quantization bit depth.

- Ring.pd Ring modulation with a sine wave.

- ChangeVol.pd Input volume control.

- Cosine.pd Cosine waveshaper.

Delay FX

- Echo.pd Simple echo effect.

- MonoDelay.pd Mono delay with low-pass filter.

- Chorus.pd Mono chorus.

- Comb.pd Comb filter.

- FreqShift.pd Frequency shifter ([hv.freqshift~] in heavylib).

Reverb FX

* Due to size limitations, implementing true reverb effects in Pure Data is difficult, so this section provides various effects instead.

- StereoDelay.pd Ping-pong delay with low-pass filter.

- StereoChorus.pd Stereo version of Chorus.pd.

- Reflection.pd A pair of short delays with different times.

- Canceller.pd Adds the phase-inverted signal from the opposite channel (vocal canceller).

- Comp.pd Compressor ([hv.compressor~] in heavylib)