Bullrider Setup Blocks

Tired of your setup blocks getting in the way of your squaring bars—or worse, falling off right when you’re trying to square everything up?

We’ve designed rear setup blocks that cradle the rear axle and hold it at the correct height straight off the table, instead of wedged between the axle and frame in the way of your squaring tool.

Up front, we’ve made a two-piece block contoured to match the frame and axle. It self-aligns when turned, so the axle sits securely—because let’s be honest, who really has a perfectly straight axle anymore?

Just sit the car on your old 1.5” blocks, or even drop a 2x4 under the frame front and back, and the chassis sits at the perfect height every time.

Our blocks are made from a PETG Material, that means:

- More durable, better in the heat, and less likely to crack if dropped than PLA variants.

- A bit pricier due to extended manufacturing times, but stronger and more UV stable than PLA.

Important: 3D-printed parts aren’t meant to take heavy loads. These blocks are printed in the strongest orientation possible, but you shocks should always be disconnected when squaring.

Simple. Stable. Squared.