Refer a friend and get % off! They'll get % off too.

Yamaha YQ50 Aerox 1997 Factory Service & Shop Manual

Yamaha YQ50 Aerox 1997 Factory Service & Shop Manual

Complete workshop & service manual with electrical wiring diagrams for Yamaha YQ50 Aerox 1997. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Yamaha YQ50 Aerox 1997 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
CARBURETOR
Float height measurement steps :
• Install the needle valve, float and float pin into the carburetor body.
• Hold the carburetor upside down.
• Measure the height distance between the mating surface of the float chamber (gasket removed) and the top of the float, using a gauge.
NOTE:
The float arm should be resting on the needle valve. It should not compress the needle valve.
• If the float height is not within specification, inspect the needle valve, float and valve seat.
• If one of these parts is worn, replace the whole set.
• If both parts are in good condition, replace the float.
• Check the float height again.
NOTE: The float height is factory-adjusted. Never try to adjust it yourself.
ASSEMBLY
Reverse the “DISASSEMBLY” procedures. Note the following points.
• Before reassembling the carburetor wash all its components in clean gasoline.
• Always use new gaskets.
Yamaha YQ50 Aerox 1997 Factory Service & Shop Manual

You will get a URLLINK (572B) file

$ 9.99

$ 9.99

Buy Now

Discount has been applied.

Added to cart
or
Add to Cart
Adding ...