noun

plural noun: errata

• an error in printing or writing.
• a list of corrected errors appended to a book.

Triangle Frenzy Swirl

No pattern corrections.

Triangle Frenzy patterns are different than most other patterns because the cutting lines follow a printed design on the fabric, not a specific measurement. Consequently there are no measurements for piece sizes. Follow the instructions and illustrations as written.

Triangle Frenzy Bouquet, too

Just in case

Step 4. If the fabric was cut into 3 pieces in step 3 instead of cutting off 1/3, then ignore the references to the long and short pieces. 

Step 5. Take 6 Floral strips, instead of 4 long and 2 short.

Continue as in the instructions.

Step 11. Gather the other 6 Floral strips. Stack them together, aligning the elements. Continue as in the instructions.

.

.

Triangle Frenzy Treble Ver Oct 2020.

Page 5. There are no steps missing, it is just mis-numbered. I'm surprised you noticed. Good job.

Page 8. Cornerstones are optional if the side borders are long enough.

Triangle Frenzy Whirlwind

Updated directions.

Step 14 DO NOT sew halves together yet.

Step 17 After sewing on setting triangles. Trim to straighten edges. Now sew the two halves together.

With so many different border prints, how do I choose which pattern works with which fabric?

Glad you asked. Click here for a FREE downloadable PDF with the entire descriptions.

Use quality quilting fabric - cheaper fabrics have a looser weave and may stretch and distort, making it difficult to match printed lines at the seams.

PRESS the fabric, do not scoot the iron across the fabric. Use Best Press starch alternative to press the fabric prior to cutting. It is very useful to stiffen the fabric and reduce stretching.

The most common reason that the pieces don't match is the ruler.

A flat tip ruler MUST be used. Use a Creative Grids 60 degree ruler, or use the template in the pattern to mark a pointed-tip ruler to cut triangles without the point on the top for the proper seam allowance. Follow the directions in the pattern for ruler placement to cut the diamond. The seams will nest and the triangles at the ends will match. If it doesn't make sense on the first read-through, just go ahead and start at the beginning, follow the directions and look at the photographs when reaching that point in the pattern. The flash of understanding will only be topped by the thrill of completion!

See this page for examples and solutions.

We use the Creative Grids 60 degree ruler, available at your Local Quilt Shop. 

Yes, you can use triangle rulers other than the Creative Grids. A pointed tip, when aligned to the edge of the fabric, will produce slightly (1/4'') smaller triangles. This is not a problem with cutting or construction (except for the Swirl click here for details), but the same type ruler (pointed or flat tipped) must be used for cutting the entire project.

Yes, someone asked, but, It won't work without a bit of geometry and math. 

CAUTION: High School Geometry lesson.

It takes six 60° triangles to make a whole six-sided hexagon. Six times 60° equals 360° circle. That is the basis of the Triangle Frenzy patterns.

If a 30° triangle ruler is used, it will take twelve pieces to make a 12 sided polygon or dodecagon. Twelve times 30° equals 360° circle. 

So there are twice as many pieces and the outside edges won't fit together without some extra pieces to fill the gaps at the edges.

OR, one edge of the 30° ruler will have to be aligned along a line perpendicular to the stripe of the fabric. Then cut two symmetrical pieces or one piece with two placements of the ruler. End of lesson.