X-Shot Micro Reshell 3 v1.2 - Sawn-Off Variant - FILES ONLY

This is a GenCo Microwerks shell for the X-Shot Micro, a tiny powerhouse of a blaster. All the hardware you need is already provided by the two Micros you need for this. You just need to print parts in the colors of your chosing and you're good to go to take a screwdriver to the Micros.

The third Reshell of this project uses two Micros, to create a double-barrelled shotgun pistol. Feels nice and has a good heft to it. (You should really stock up on these at this point.)

---

All parts can be printed on a bed of 180mm edge length. You can print most pieces without supports.

The assembly instructions can be found here -> https://wildwestscifi.net/x-shot-micro-reshell-3-double-barrelled-assembly-instructions

---

https://www.youtube.com/watch?v=OLrYHbu8xrg <- Maritimefoam has a look at the blaster, and provides an assembly video.

https://www.youtube.com/watch?v=SEfCjL7GyI4 <- XFoxGames is having a quick look at the first 3 Reshells.

https://www.youtube.com/watch?v=7Czc9XWtYlg <- Dr Flux is also having a quick look and assembly thoughts on the blaster.

---

Changelog: 

v1.0 

- Initial Release.

v1.1

- Added a little spacer ring, to clearly separate the triggers from each other.

- Made a few small cosmetic adjustments to the grip, to eliminate some uncomfortable edges.

v1.2

- Made the fins on the body pin (front) longer, so it grips better on printers with looser tolerances.